heat on one side only on a 2005 chrysler sebring limited.
Asked by migration_foxsay Nov 02, 2013 at 09:38 PM about the 2005 Chrysler Sebring Limited Sedan FWD
Question type: Maintenance & Repair
I have a 2005 Chrysler sebring with a 3.0 liter. It only puts heat out of the
passenger side. The driver side is cold as ac. the fan works great. keep in mind, i
have thought it was an actuator motor for the blend doors but both the temperature
control and direction control switch are cable run instead of electronic. I don't think
it could be a heater core because it pumps out pretty good warm air on the right
side. any ideas would be very helpful. Thanks.
6 Answers
migration_judge_roy answered 11 years ago
okay...here's a blowup of the whole magilla~
migration_judge_roy answered 11 years ago
okay they are electrical...perhaps one is burnt...perhaps you are suffering from an undervoltage condition because the battery is old and the main connection 1/0 cable to the chassis is corroded from 300 amp service and needs a coarse wirebrushing to restore proper ground...no longer a "semi- conductor" with corrosion...will bring stuff around to normal....I know~ http://www.partsgeek.com/gbproducts/DC/1541-05266618.html? utm_source=google&utm_medium=ff&utm_content=DN&utm_campaign= PartsGeek+Google+Base&utm_term=2001- 2006+Chrysler+Sebring+Air+Flap+Actuator+Dorman+01- 06+Chrysler+Air+Flap+Actuator+2003+2005&gclid=CMDc0ePsx7oCFSd p7AodbQQAMg
migration_judge_roy answered 11 years ago
Look at the fuse to see that it is NOT burnt, we are suffering from an undervoltage condition....perhaps it IS a corroded MAIN ground...perhaps the battery terminals need to be cleaned....perhaps if the battery is older than five...it's time to replace that one~
migration_judge_roy answered 11 years ago
We enjoyed servicing your need for free advise...leave a virtual quarter in the tip jar by marking these helpful...or be a thief stealing intelligence from those silly enough to put it forward...out there for you~
migration_foxsay answered 11 years ago
I have just put a new battery in it a week before.
migration_judge_roy answered 11 years ago
...did you check the actuator harness for continuity?...short?~