My can shaft sensor is bad on my 2001 Chrysler Sebring that what came up on the code. Will this cause my car not to start.

Asked by wildroselane Jul 08, 2015 at 11:04 PM about the 2001 Chrysler Sebring LXi Sedan FWD

Question type: Maintenance & Repair

Check engine light comes on took it to be scan and that's what the
code came up with battery is good starter is good when I start the
car the the fuse blows that says start/fuel which is a 20amp fuse.
This as happen before all I did was replace the fuse and it turn over I
all so notice this fuse works the turn signal and radio.

9,825

schalk answered 9 years ago

YES, CAM AND CRANK SENSORS ARE THE MOST COMMON THINGS CAUSING A CARE NOT TO START

1 people found this helpful.

Mark helpful

Lee answered 6 years ago

Could be a starter relay. If the Relay gets to warm it will pop the fuse every time.

1 people found this helpful.

Mark helpful