Does anyone know how to get the window guides off my Chrysler 2000 300M car?
Asked by Dublindee Dec 10, 2016 at 12:22 PM about the 2000 Chrysler 300M FWD
Question type: Maintenance & Repair
I bought new window guides to replace my bent window guide on my driver side window, but I cannot get the old guide off it is glued on and I have heated it with a hair dryer but still cannot move it.
2 Answers
sounds like a 'Front Door Glass Run Weatherstrip' *** REMOVAL*** 1)remove flag/speaker cover, door trim pnl, watershield , as necessary, and pull up cup support brkt. 2)remove door glass 3) loosen side mirror, 4) pull weatherstrip from lower front channel above door latch. 5) Pull run weatherstroip from window frame channel...*** INSTALLATION *** 1) CLEAN RUBBER BUTYL MATERIAL from door flange area. 2) Place door run weatherstrip in position on window frame channel. 3) Push door run weatherstrip into windoew frame channel. 4) Push weatherstrip into lower front channel above door latch. 5) Install door glass 6) Tighten side mirror 7) install pull cup support brkt, water shield,door trim pnl, and flag trim ref. ELH 300m service manual, pg. 23-20 rubber butyl is not mentioned on installation. but, if it came off, it didn't grow there.
then there is the 'regulator roller channel' the bottom of the window sets in the channel.