Chrysler Sebring starting problems

First make sure that all of your battery connections are clean. Make sure your ground to the battery is clean also. If everything is good, your starter, ignition, or neutral safety switch could be the issue. If it will not start again, try starting in Neutral. Move the shifter around while trying to start it. If no dice, locate the starter, have someone hold the key to the ON position, as they do that, rap on the starter with a hammer. If the engine suddenly turns over, you have a bad starter. If that doesn't work, you may have a bad ignition switch. You can run a wire from the positive battery terminal and touch it to the positive side of the starter. If the starter turns over, your ignition switch is faulty.

Take the off have tested at Auto zone it's. Free.

I had a problem with my 2000 Sebring stalling out when Idling, had tune up done. Fixed that problem but still stalling when accelerating. Mechanic went over car really good, checking sensors and valves. When checking the wiring, found that the ground wire for the fuel pump was corroded so the pump was getting power surges. Once he fixed that and replaced the damage fuel pump, car runs great. Fingers are crossed!!! Hope this helps.

Work for 30mint and of tell the next day he can start