Asked by GuruWGXWH Jun 04, 2018 at 11:03 PM about the 2006 Nissan Frontier XE King Cab SB with manual
Question type: Maintenance & Repair
very very bad they make my truck nissan frontier Ex 2006
to repalce to take out the ignation coil or park plus is the hell to take out all the
bolt and nuts very complica and cost alot of money put pay a mecani so
better to sell it
very very bad they make my truck nissan frontier Ex 2006 to repalce to take out the ignation coil or park plus is the hell to take out all the bolt and nuts very complica and cost alot of money put ...
2006 Nissan Frontier XE King Cab SB with manual
-
Maintenance & Repair
I have a 2000 Nissan Frontier, 4 cylinder, it has no problem starting, but there's a hesitation when accelerating, then it clears up, but then a vibration begins to take place when I maintain a ...
2000 Nissan Frontier 2 Dr XE Extended Cab SB
-
Maintenance & Repair
2006 Nissan frontier xe 4 cylinder has no heat. When blower is on low you can put your hand up to the vent and feel some heat but turning it up any higher the heat doesn't overcome the cold tempera...
2006 Nissan Frontier XE King Cab SB with manual
-
Maintenance & Repair
I have attached three photo's of my V6 4.0 2006 Nissan Nismo engine. Which port is the low side service Port? Thank You very much!!
2006 Nissan Frontier Nismo 4dr King Cab 4WD SB with automatic
-
Maintenance & Repair
I am trying to replace a windshield wiper linkage on my 2000 Nissan Frontier, got it back together and linkage arm popped off again. Noticed motor made a complete circle. Should it do that?
2000 Nissan Frontier 2 Dr XE Extended Cab SB
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.