2012 ford escape grins going into gear will not move in any gear
2012 ford escape was driving 10 mph and it stopped would not go into any
gear and when try it grins very load
look at the abs sensor ring on the inside of the wheel hub. Mine has a crack , and when I was attempting to remove my rotor, the ring came off the hub. I freaked on the test drive after brake work. It was like the tranny was fried. i just took it for a spin after repositioning the ring and it drove normal. Each wheel has a abs sensor assembly and seems a failure or broken component may casue this erratic behaviour. giid luck - John
2012 ford escape was driving 10 mph and it stopped would not go into any gear and when try it grins very load
2012 Ford Escape Limited FWD
-
Maintenance & Repair
I have replaced the gear shift cable, now the vehicle will not go into gear. I have disconnect the cable from the transmission and tried to manually shift the transmission into gear with the car ja...
2013 Ford Escape SEL AWD
-
Maintenance & Repair
i was was driving it it ailed uphigh slowed down i pulled over and i couldnt get it to go into gear at all
2005 Ford Escape
-
Maintenance & Repair
i changed the oil in my 2013 ford escape and now when i put it in gear it wont go
2013 Ford Escape SE FWD
-
Maintenance & Repair
2005 escape xlt 4wd 3.0 dies when i put it in gear
2005 Ford Escape Limited AWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.