Car starts but will only stay running if i keep my foot on the gas.

95

Asked by rachel_37 Aug 11, 2016 at 08:24 AM about the 1995 Chrysler Concorde 4 Dr STD Sedan

Question type: Maintenance & Repair

My 1995 Chrysler Concorde starts right up o check
engine lights no hesitation,but it stalls out if i don't
keep my foot on the gas to keep it idling,I found the
breather hose had a big crack in it,i changed it and
still it does the same thing,could i have a clogged
fuel filter?or do i need to replace the idle control
valve?

103,435

KenF answered 8 years ago

Idle Air Control valve. Also check around throttle body for vacuum leaks. IAC is what lets the engine breath when the throttle plate is closed, which is the case when you are not pressing the gas pedal.

2 people found this helpful.

Mark helpful

Your Answer:

Car starts but will only stay running if i keep my foot on the gas. 1 Answer

My 1995 Chrysler Concorde starts right up o check engine lights no hesitation,but it stalls out if i don't keep my foot on the gas to keep it idling,I found the breather hose had a big crack in it,...

1995 Chrysler Concorde 4 Dr STD Sedan

-

Maintenance & Repair
The malfunction indicator light came on (OBD II) and the car started running as if it were misfiring. It only has 50,000 miles on it. I checked the tranny fluid and it was ok. What else can I check? 2 Answers

Yesterday for the very first time, the OBD II light came on my panel. When I first started my car it was running very rough, even at idle. I wasn't sure what the light was and pulled over to see, th...

2000 Chrysler Concorde LXi

-

Maintenance & Repair
Relays in the door 1 Answer

I changed my fuel pump and everything and now my car won't start. Are there any relays in the door that go to the fuel system that will keep my car from starting? If u spray starting fluid in the ...

2000 Chrysler Concorde LX

-

Maintenance & Repair
1998 Chrysler Concorde wouldn't shift properly, ran at high rpms and the spedometer would read 80 mph even when I was only going 45.Replaced the input & output sensors and now can't get car to move. 2 Answers

My 1998 Chrysler Concorde wouldn't shift properly. I'd get to 45 mph and it wouldn't shift. It was running at high rpms and the spedometer started reading about 80 mph. I replaced the intake and ...

1998 Chrysler Concorde 4 Dr LX Sedan

-

Maintenance & Repair
Our 2004 2.7 Concorde sounds like the timing chain is loud on cold starts only. 1 Answer

I have only heard the noise on cold starts. After it is started you can shut the engine off and start it again with no noise. No dash lights or codes show. It does not sound like lifters to me. Any th...

2004 Chrysler Concorde LX

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.