Check engine light
Code read that i needed a new purge valve. Put
new one on. The light hasnt gone away. Its been 3
weeks now
Hornet_2497 answered 6 years ago
Sometimes they reset after several cycles but I like to disconnect the battery 10 minutes to cancel the code/light and see if it comes back. Hopefully it's fixed.
Code read that i needed a new purge valve. Put new one on. The light hasnt gone away. Its been 3 weeks now
2012 Chevrolet Impala LT FWD
-
Maintenance & Repair
2013 chevrolet impala check engine light came on right after it turn over 75,000 miles is that normal?
2013 Chevrolet Impala LTZ FWD
-
Maintenance & Repair
Just bought ‘04 Impala. Was running fine. Guy claimed to have put all new brake lines in. Now engine light is on. Stopped at Auto Zone and had a scan done. Came back it was gas cap. Day after I bo...
2004 Chevrolet Impala FWD
-
Maintenance & Repair
My impala ss has this problem, Driving on road, service stablitrac light comes on, then service traction control light comes on, They both flash on, engines starts to run really rough. Next ch...
2008 Chevrolet Impala SS FWD
-
Maintenance & Repair
My check engine light is on and solid on my 2006 impala LT 3.9L V6. the message center is telling me to tighten my gas cap... ive replaced gas cap 4 times now and got the car scanned for codes...got...
2006 Chevrolet Impala 3.5L LT FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.