Asked by Z31999 Mar 30, 2017 at 02:32 PM about the 1999 BMW Z3 2.8 Roadster RWD
Question type: Maintenance & Repair
When I apply jumper cables from another car the Z still won't start and keeps clicking just like when the battery is dead. All electrical turns on but it appears that it still is not getting enough electricity
Bad starter or bad battery connections - clean and tighten the battery cable ends. A battery with an internal short can make it hard to jump start the car.
sounds like a starter solenoid- if you keep "applying" jumper cables to your BMW you are going to fry some electronics in there- then all bets are off-
When I apply jumper cables from another car the Z still won't start and keeps clicking just like when the battery is dead. All electrical turns on but it appears that it still is not getting enough e...
1999 BMW Z3 2.8 Roadster RWD
-
Maintenance & Repair
hello I have a 1999 BMW Z3 2.5 it WILL not start and it's killing me. it engine turns over runs for a few seconds but then dies and cuts off. I have replaced the spark plugs replaced the fuel and ...
1999 BMW Z3 2.3 Roadster RWD
-
Maintenance & Repair
I turn the key to ACC & the radio comes on and the dash lights flash, then I try to start it and everything goes dead
1997 BMW Z3 2.8 Roadster RWD
-
Maintenance & Repair
Bmw z3 makes a squeaky noise when first being g started in the morning
1998 BMW Z3 1.9 Roadster RWD
-
Maintenance & Repair
I put the key in the pass door lock and it just spins. Dealer says I have to replace the Door handle front lock/key.
2001 BMW Z3 2.5i Roadster RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.