It will turn over but has no spark
19 Answers
Krankenwagen2010 answered 9 years ago
Let me see if I remember!!! I did have a neon while ago and image crank sensor was bad
Krankenwagen2010 answered 9 years ago
I also remember having no signal going to the injectors
But would that cause it not to not have spark? This is my first neon I know absolutely nothing about this car
With the crank sensor be enough to cause it to just leave me on the side of the freeway because it was running and it just shut off never started back up
Krankenwagen2010 answered 9 years ago
Yes they will go bad without any warning. How do you know you don't have any spark?
Put screw driver in spark plug hole and just put in new crank sensor still no luck
Tomorrow I'm changing the camshaft sensor and going from there I'm going to change all the sensors the diagnostic said it was or could have been
Krankenwagen2010 answered 9 years ago
Do you have a code reader? Will help to get trouble codes
Krankenwagen2010 answered 9 years ago
Also make sure your timing belt didn't snapped open the oil cap and have someone crank and see if you see the camshaft move
Yeah had it hooked up to a code reader give me three different codes
One was crankshaft sensor camshaft sensor throttle position sensor MAP sensor and the other option is the one I fear the most timing belt
Thanks for your input krankenwagen2010 I can tell you know what you are talking about bro
Krankenwagen2010 answered 9 years ago
If you got codes for crank , cam maybe you are off timing or maybe no distribution at all. Check the belt. Hope only jump a tooth if is the case. If is snapped this engine will damage valves :-(
I have 03 neon been going through all the same problems. Got bored one day and scrubbed and cleaned all grounds,put on new washers, checked all grounds and for any loose connections to anything. Fired right up after that . Hope this helps someone as it worked for me .
What are grounds I have the same problem
I change my transmission and now my 2005 dodge neon wont start its nat firing
Please Help I Have The Same Problem!! It Has No Spark Changed The Cam & Crank shaft Position Sensors, The Distributor, The Battery, And The Ecm Computer (Haven't Got It Programmed Yet)