I am not familiar with that model engine, but clean up the area real well. it might be part of a housing attached to the engine that you can remove, that will need replacing. Check with an engine builder or Toyota dealer.
But looking at it again, it could be the intake manifold that you will have to replace. Doh!
I was replacing the coolant temp sensor an the housing cracked , I’m at a loss don’t know what to do pls help !!
1983 Toyota Pickup 2 Dr STD Standard Cab SB
-
Maintenance & Repair
K my truck has the 22 r it was fuel injected and put a webber my truck will run awsum and the when I start to go up hills it will die kinda then I will start figure something out and I waited 5 ten...
1986 Toyota Pickup
-
Maintenance & Repair
Today took my 90 Toyota 4x4 w/3.0 for a short 14 mile round trip drive. On my way to my destination I noticed the coolant temp was lower and the oil pressure was higher then they should be given th...
1990 Toyota Pickup 2 Dr Deluxe 4WD Extended Cab SB
-
Maintenance & Repair
ive chenges the igniter, distributer, new distributer wires, the coils been changes, new distributer cap, roter lookes fine. but it still loses spark. it will start fine and idle gread then just loose...
1992 Toyota Pickup 2 Dr SR5 4WD Extended Cab SB
-
Maintenance & Repair
Aloha: My speedo quit working recently after a couple weeks of jerky, on-off behavior. Sometimes the odo would continue functioning, but not always. I made the choice to get a new speed sensor bu...
1992 Toyota Pickup 2 Dr Deluxe 4WD Extended Cab SB
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.
