87 bronco 5.0 won’t start
Asked by Bronco87 Feb 25, 2019 at 09:30 AM about the 1987 Ford Bronco Eddie Bauer 4WD
Question type: Maintenance & Repair
My bronco would not start or crank. I tried
jumping the starter solenoid with screw driver
it would not crank. I replaced the solenoid it
still won’t crank when I turn the key but now
it will start when I jump the solenoid. Any
ideas??
2 Answers
Is this solenoid/relay under the hood on the fender lining? So you jumped the two large terminals? There should be a smaller terminal, ignition feed/crank position. If no voltage something wrong with ignition switch or that wiring circuit. I don't have wiring diagram for your model year, so I can't track it. Just my opinion.
1 people found this helpful.
Best Answer
Mark helpful
It was the ignition switch. It started right up thank you
1 people found this helpful.