Help me, someone, please!

Asked by BEERZ Mar 12, 2018 at 02:12 AM about the 1988 Ford Bronco II XL 4WD

Question type: Maintenance & Repair

I have a 1988 ford bronco ii 2.9 liter. I have replaced fuel filter, fuel regulator, distributor and ignition module, spark plugs, starter relay/solenoid, negative and positive battery cables. The coil has spark. #1 and 2 do not have spark, while 3,4,5,6 do

Eric answered 6 years ago

Maybe spark plug wires.

Mark helpful

26,290

Jorge answered 6 years ago

Yes, I agree, replace the spark plug wire harness, that may be your problem. You do not list them as replaced.

Mark helpful

Your Answer:

Help me, someone, please! 2 Answers

I have a 1988 ford bronco ii 2.9 liter. I have replaced fuel filter, fuel regulator, distributor and ignition module, spark plugs, starter relay/solenoid, negative and positive battery cables. The coi...

1988 Ford Bronco II XL 4WD

-

Maintenance & Repair
I'm having starting problems need help please!!!! 3 Answers

I have a 1988 ford bronco 2 XLT, I purchased it for fairly cheap cause of damage to the windshield, however a couple days went buy and it wouldn't start. I've owned one of these in the past and was...

1988 Ford Bronco II XLT 4WD

-

Maintenance & Repair
I need some help with my 88 ford bronco ii 2.9 v6. I just finished rebuilding the motor and i went to start it and the only thing i got was the check oil light. 7 Answers

All the wires are hooked up ive checked the starter switch clutch interlock switch replaced the starter solenoid and battery. I cant figure out whats wrong with it help please

1988 Ford Bronco II Eddie Bauer 4WD

-

Maintenance & Repair
Hey guys, i have a 1985 Bronco II, 2.8L, XLT. There is a hose that is missing from the side of my air filter housing that leads to the front of the vehicle. I have searched high and low for this replacement hose. I think my biggest problem is that I do not know what the part is actually called. Does anyone know what this part would be called? Thanks, upfront, for the help. 5 Answers

Hey guys, i have a 1985 Bronco II, 2.8L, XLT. There is a hose that is missing from the side of my air filter housing that leads to the front of the vehicle. I have searched high and low for this rep...

1985 Ford Bronco II XLT 4WD

-

Maintenance & Repair
I bought new window seals for my 88 Bronco II but not sure on how to replace them . Can someone explain it to me please ? 6 Answers

i have a 88 ford bronco II XLT with vent windows - non power window - and Im wondering how to replace the window seals . I bought a brand new clip on type set of seals !!!

1988 Ford Bronco II

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.