I have a 88 Bronco II that won't start
Asked by SJS61 Oct 04, 2014 at 06:11 PM about the 1988 Ford Bronco II Eddie Bauer 4WD
Question type: Maintenance & Repair
I have replaced a starter (burned-up) , start solenoid (old one stuck on), start switch.....after all this ....solenoid gets stuck on ....stays on after switch is turned off, even after ignition wire on solenoid is pulled off. won't start engine....any idea???
5 Answers
Recheck the starter wires, at cylinoid,and make sure they are not crossed.
1 people found this helpful.
Best Answer
Mark helpful
No crossed wires made sure of that, found rusted relay , replaced and it started up.....going to give it a test drive and see if that was the problem.