Asked by OUTLAWWOMAN May 13, 2015 at 08:57 PM about the 1988 Ford Bronco II Eddie Bauer
Question type: Maintenance & Repair
NEW FUEL PUMP COMES ON BUT NOT ENOUGH PRESSURE TO START BRONCO
2 1988 AND HOW TO WIRE RELAY
newbronco2owner answered 9 years ago
There is two fuel pumps one in rank one in frame rall need more help just ask just went though the same thing
NEW FUEL PUMP COMES ON BUT NOT ENOUGH PRESSURE TO START BRONCO 2 1988 AND HOW TO WIRE RELAY
1988 Ford Bronco II Eddie Bauer
-
Maintenance & Repair
To fail like if the engine is not getting enough gas its a 2.9liter efi
1986 Ford Bronco II XLT 4WD
-
Maintenance & Repair
To fail like if the engine is not getting enough gas its a 2.9liter efi
1986 Ford Bronco II XLT 4WD
-
Maintenance & Repair
We removed the rear line and there is flow out of the low pressure pump. Is there something we need to do. We replaced the the relay and filter also,
1988 Ford Bronco II Eddie Bauer 4WD
-
Maintenance & Repair
So I have a 89 bronco 2 that isn’t getting any fuel. I’ve replaced the fuel pump, and fix the inertia switch that cuts off fuel to the engine if it is in a wreck. I’ve tried googling left and right...
1989 Ford Bronco II XLT
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.