Engine crank but no fire from ignition coil
Asked by Jason May 18, 2017 at 12:10 AM about the 1994 Dodge Dakota SLT Club Cab 4WD
Question type: Maintenance & Repair
I have a1994 Dodge Dakota SLT 4x 318 Magnum,
was driving to work and truck just shut off.
Computer code 11showed up for crank position
sensor. Changed CPS an I'm still getting no spark.
I'm getting power to the plug at bottom of ignition
coil but nothing from coil,to distributor,or plug
wires. I replaced ignition coil and still getting no
fire. I've read up on Google an see many people
have had some issues with wire corrosion under
fusepanel on driver side under the hood, I've
repaired several wires that had corrosion on driver
an passenger side an still no fire. I need some help
plz.and thanks
10 Answers
Almost forgot that I check power at connecter to bottom of ignition coil with test light and both contacts have constant power when key is on and if I was reading the information correctly isn't it only supposed to have power while engine is being cranked over?
Dakotaman201760 answered 7 years ago
I have a 2002 Dodge Dakota 3.9 4x4. What mine was doing was after it got to full operation temperature, and you would shut it off,it would not start back up until it cooled all the way down,before it would restart. I had the codes read on it,and I had a bad crank sensor. Autozone had one for 80.00. I got one off of EBay Motors for 17.00. Have a great day.
Did you figure it out yet. Mine just did same. Thing
I have a 95 dodge dakota v6 I put a new coil an it still won't start
I got a 97 dodge Dakota 4 cyl...I changed the coil and the distributor and still not getting fire to plugs... HAS ANYONE FIGURED THIS ISSUE OUT YET...IF SO PLEASE TELL ME
Same issue, im going to cam sensor, I checked it the resistance is right, but that is all that makes sense
Guru9DTBC9 answered 4 years ago
check your spark plug wires had bad coil wire replace them all
Guru9DTBC9 answered 4 years ago
if no spark the fuel pump will go in limb mode it will seem that you have no pressure
