Clutch slave cylinder
Asked by Kennyf250 Jan 12, 2019 at 12:01 PM about the 1986 Ford F-250 XLT Extended Cab 4WD LB HD
Question type: Maintenance & Repair
Ok so i have a 1986 f250 4wd with a 4 speed
manual and a 460. So i replaced to clutch and im
trying to reinstall the clutch slave cylinder but it
seems to be stuck in the engaged position, nothing
happens when i push the clutch pedal. It didn't
seem to have a problem before i replaced the
clutch. Any ideas?
4 Answers
*not engaged position* it is stuck as if the clutch pedal is pressed
If the pedal doesn't go down then the line that goes into the transmission is not all the way in if it is all the way in then open the bleeder and press the clutch pedal but if it go all the way down then make sure the bleeder is closed before you let off the pedal
Ok so i was able to get thr slave cylinder installed. But now the clutch pedal goes to the floor and stays there