lincolnscott49 answered 5 years ago
Water pump seep hole is most likely leaking meaning seal is gone and a new one is needed. easy job to do but remember to loosen the pump pulley bolts before removing the serpentine belt. Drain the antifreeze and pay attention to the torch of the bolts when installing as well as purge the antifreeze as you fill .
Have a high mile 2007 ford crown victoria p71 .and a low mile 2006 ford crown victoria p71 engine and transmission wondering if it will work in 2007
2007 Ford Crown Victoria Police Interceptor
-
General
My car was overheating so i replaced the thermostat, but now it's leaking fluid from the front end that smells like coolant........... i just refilled that also.
2007 Ford Crown Victoria Police Interceptor
-
General
I have a 2007 P71 crown Vic with 139,000 miles on the body and 83,000 miles on the engine. I swapped the engine from my 08 grand marquis. After the engine swap the car ran great for a little while...
2007 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
My crown victoria will go into reverse but won't go into drive or any any other gear. What could be wrong?
1999 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
I was looking to buy a 98 crown vic LS with 123, 498 miles on it for about $1,250 thats what the dealer is asking in delaware should i be cautious about this vehicle because it is a crown vic for ...
1998 Ford Crown Victoria 4 Dr LX Sedan
-
General
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.