Asked by JoeyGoomba484 Nov 23, 2021 at 02:26 PM about the 2014 Ford Fusion SE
Question type: Maintenance & Repair
No engine light on, engine has a misfire. Changed
oil, plugs and coils. Mechanic said fuel pressure
and all is good. Any other ideas? Reading maybe
it’s the computer??
Guru9H85Q3 answered 2 years ago
There is always a reason. ECU/PCM may be malfunctioning but before going that far I would first check: Spark-plugs one by one, spark-plugs wire, Ignition coil-to-Spark- plugs and wiring, fuel injector defective or defective spry pattern, fuel filter clogged, Intake Manifold Air Leaks. Thanks.
No engine light on, engine has a misfire. Changed oil, plugs and coils. Mechanic said fuel pressure and all is good. Any other ideas? Reading maybe it’s the computer??
2014 Ford Fusion SE
-
Maintenance & Repair
Recently my car started shaking ( while on and running ) and my check engine light began flashing on and off. I took it in to get a scan and the codes diagnosed a misfire with the coils. We replace...
2010 Ford Fusion SE
-
Maintenance & Repair
My wife just called me on her way to work. She has no heat in the car whatsoever. Does not matter where se position the dial, no heat comes out anywhere. The Temp gauge shows normal operating temp
2013 Ford Fusion SE
-
Maintenance & Repair
I have a leased 2014 Ford Fusion. This past winter it wasn't very cold where I lived. I keep it in a garage. When I went out one day, it would start and the car had to be jump started. I had just dr...
2014 Ford Fusion SE
-
Maintenance & Repair
I have a 2014 Ford Fusion SE. I have been offered a set of tires and rims 245/45ZR19. Will these fit on my Fusion?
2014 Ford Fusion SE
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.