I have a 98 gmc with a 2.2l it has gas leaking into my number 2 cylinder i took my intake off turn the key on and gas came out of that injector changed it and it's still doing the same thing any help

70

Asked by Ryan Apr 24, 2014 at 01:00 AM about the 1998 GMC Sonoma 2 Dr SLS Sport Standard Cab Stepside SB

Question type: Maintenance & Repair

I'm not sure if I have the vacuum lines right
but I'm not sure if that would cause it to
not close

40,195

James answered 10 years ago

unplug the elect. connector, it should stop ,if it does the driver in the pcm may be stuck on. under normal running the jacks plugged on to it should pulse test with test light

Mark helpful

Your Answer:

I have a 98 gmc with a 2.2l it has gas leaking into my number 2 cylinder i took my intake off turn the key on and gas came out of that injector changed it and it's still doing the same thing any help 1 Answer

I'm not sure if I have the vacuum lines right but I'm not sure if that would cause it to not close

1998 GMC Sonoma 2 Dr SLS Sport Standard Cab Stepside SB

-

Maintenance & Repair
I have a 1997 gmc Sonoma and when I turn the headlights on it blows the fuse I took out the bulbs and it still blows the fuse 1 Answer

My 1997 gmc Sonoma blows the fuse when I turn on the headlights. I even took out the bulbs and it still blows the fuse

1997 GMC Sonoma 2 Dr SLE Extended Cab SB

-

Maintenance & Repair
When I turn on the headlights the fuse blows and I no longer have headlight or tail lights but the brake lights and turn signal still work. I even took out the bulbs and it still blows the fuse 1 Answer

On my 1997 Sonoma when I turn on the headlights it blows the fuse and I even lose my tail lights but my brake light and turn signal still work. I took out all the bulbs and it still blows the fuse

GMC Sonoma

-

Maintenance & Repair
I have a 03 gmc sonoma I was driving down the road and it died. I started it bck up then stopped at a light and it died and wouldn't start back. It has gas in it I replaced the coil. 5 Answers

I also replaced the ignition module and it still will not start. I'm not getting any fire. What else could it be.

2003 GMC Sonoma SLS 2WD

-

Maintenance & Repair
I installed a fuel pump on my 2002 GMC Sonome engine 4 cyl. It started righd not startet up. But, after driven 2 miles, stalled out and died. Since then I could start only after taking out pump out of tank and reinstalled. Oil pressure is more than 40 PSI. I can not find any voltage from terminal.. I put a hotwire (jumper) from 87 terminal to 30 Terminal in fuel pump relay terminal, still no juice. I put a wire from batter to straight to pump . The new pump made noise . Still could not start. In this morning I put a jumper from 87 terminal to pump. I managed the engine running. I could start without jumper about 5 times. While the engine running, I decided to take my truck to road test. Whiel the engine running, I was gathering some tools and equipment for in case of broke down, the engine shut off. Why does my truck do this? I need help, please. 3 Answers

I installed a fuel pump on my 2002 GMC Sonome engine 4 cyl. It started righd not startet up. But, after driven 2 miles, stalled out and died. Since then I could start only after taking out pump out of...

2002 GMC Sonoma SL 2WD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.