2006 Chevrolet Uplander ABS/Traction control/Stability control

Asked by Scott Jun 28, 2018 at 01:15 PM about the 2006 Chevrolet Uplander 1LT FWD

Question type: Maintenance & Repair

Hi

2006 Chev Uplander FWD... ABS light on, sometimes brake light.
ABS/Traction/Stability warning on.

Ran code scanner.. said failure of front and rear left side bearings.. replaced
(left front definately needed replacing, it was worn)

Cleared codes

ABS light back on... checked codes again.. now problems with both left front
and left rear bearings.. and also right front.

Checked all bearing resistances with wires disconnected.. virtually zero
resistance.

Checked voltage output to all 4 wheel bearing sensors.. all 4 were consitantly
1.62v when checked with DMM from pin to pin..

When checked from one pin to ground, = 2.15v
When checked other pin to ground = 3.7v

Is this a problem with EBCM module itself?

1 Answer
1,940

Fadi answered 6 years ago

could be, also could be a problem with the wiring, its best if you get a high end scanner and read the values that shows in live data.

Mark helpful

Your Answer:

Related Questions

Shortcuts

Search Chevrolet Uplander Questions

CarGurus Experts

  • #1
    Kelly Mayo
    Reputation
    760
  • #2
    John Leone
    Reputation
    660
  • #3
    GuruDTVT
    Reputation
    620
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Toyota Sienna
37 Great Deals out of 857 listings starting at $3,000
Used Honda Accord
47 Great Deals out of 986 listings starting at $1,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.