driveshaft or transmission?
Okay so I have an 85 c10 Silverado long bed that has around 178k miles. Its a 5.0 350 engine and had a 700r4 tranny. The tranny I just took out was a 700r4 and I replaced it with the th350 that was almost new with no problems. I checked and made sure everything was connected and tightened correctly but I used the 700r4 driveshaft instead of the one the th350 had on it and I finished everything today and just put fresh fluid into it and a full tank of gas and when I put it into reverse I have to rev it really hard for it to even start reversing then it moves extremely slow and I can hear and see that all the gears are shifting correctly and the driveshaft moves in neutral but when I put it in reverse it doesn't spin. any suggestions should I replace the driveshaft with the transmissions original driveshaft?