Unavle to remove Alternato 1999 Ford Contour 6cy
10

Asked by 1Madjack Jul 19, 2015 at 02:37 AM about the 1999 Ford Contour 4 Dr SE Sedan

Question type: Maintenance & Repair

I am removing the alternator from my 199 Ford Contour, 6CY. I'm down to the bolt at the lower left corner. It's very difficult to get a socket on it. When I do there is no room to move the wrench, no matter which angle I try. None of the forums I've read mention this problem and how to get the bolt off.

1 Answer
10

1Madjack answered 9 years ago

Yes, That allowed me to get my hand around the bracket to feel the bolt and get a socket on it, but there doesn't seem to be room back there to move the wrench, thanks

1 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • Unavle to remove Alternato 1999 Ford Contour 6cy 1 Answer

    I am removing the alternator from my 199 Ford Contour, 6CY. I'm down to the bolt at the lower left corner. It's very difficult to get a socket on it. When I do there is no room to move the wrench, no ...

    1999 Ford Contour 4 Dr SE Sedan

    -

    Maintenance & Repair

  • 1999 Ford Contour Starting Issues, ran rough 2 Answers

    1999 Ford Contour 4 cyl. 2.0 lts. automatic. 126,000 miles. Car acted up last 3 or 4 days - when stopping at a traffic light almost died like it wouldn't go into idle, then it kicked in fine. Yesterda...

    1999 Ford Contour 4 Dr SE Sedan

    -

    Maintenance & Repair

  • Where does the negative battery ground wire hook to on 1999 Ford contour? 3 Answers

    I remove the starter to have it tested and it was fine I noticed the negative ground wire is unhooked and I don't know where it goes.

    1999 Ford Contour 4 Dr SE Sedan

    -

    Maintenance & Repair

  • 1999 Ford Contour Will turn over, But will not start 2 Answers

    Bought used 1999 ford Contour about 2-3 weeks ago. The day I bought it it had the issue with starting. It will start the first time, say first drive of the morning, but if I turn engine off and com...

    1999 Ford Contour 4 Dr SE Sedan

    -

    Maintenance & Repair

  • Ford Contour jerking 3 Answers

    I have a 96 for contour it jerks while accelerating and while mantaining a steady speed. sometime i can pull over and turn the car off wait a min. and go and it will stop. normally starts when the car...

    1996 Ford Contour

    -

    Maintenance & Repair

Shortcuts

Search Ford Contour Questions

CarGurus Experts

  • #1
    BobTrier
    Reputation
    410
  • #2
    Kidd1214
    Reputation
    380
  • #3
    David Koppa
    Reputation
    370
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.