HOW ADJUST LOW BEAM BULB
2 Answers
The adjustment holes are in the black plastic covering the radiator support, to each side more or less in line with the headlights. They are marked with an "A" and rotation directions for UP and DOWN. The Phillips screwdriver goes into the hole about 45 degrees from vertical and engages the adjusting rack, where the teeth of the Phillips screwdriver are the pinion. If you shine a flashlight down the hole you can see the rack teeth and all becomes clear. You can do it shining them against your garage door, or ant wall, and make the left, drivers, a bit lower than the right side
6 people found this helpful.
any wall not ant wall...sheesh pay attention David
2 people found this helpful.