2006 jeep liberty wont start

255

Asked by kaykay7110 Apr 15, 2013 at 04:02 PM about the 2006 Jeep Liberty Renegade 4WD

Question type: Maintenance & Repair

replaced starter, battery, tested alternator fine, replaced crankshaft sensor and it still wouldnt turn over
then we replaced the camshaft sensor and it turns over and and wants to start but not starting the
engine??

31 Answers

hate to say it, but perhaps is too soon to tell....okay, put a compression tester on there to see if it's getting good compression...think that perhaps you've jumped a timing belt tooth~

255

Well if you want to know how this happen I was driving in the rain the other night and a car almost hit me so i pressed on my breaks and my breaks shudder then i went back to driving normal then 3 mins later I kind of feel my jeep loose power I look down and my check enginge light is flashing and when i pressed on the gas i heard like dudddddd from the engine but NOT like it was a rod and my rpm was not going past 2k and so i didnt want to pull over on the highway so i pressed on the gas till i got to the exit and then pulled in to a parking lot and it acted like it wanted to die so i pressed on the gas and it went and then i parked and shut it off. when i tried to start it again it acted like it had a dead battery so I had it towed back to my place replaced battery sarter then tested alternator cranshaft sensor still would turn on act like it was gone turn over but then would stop, so we changed the cam sensor and it turns over not stopping just not starting the engine

7 people found this helpful.

I'm so sorry kaykay. This does not sound like it's going to have a cheap solution. Have someone pull the timing case off and note the position of the sprockets, since you were still driving it, all hope is not lost, I can price out a timing chain kit, which includes a tensioner and wear foot, but will take a little more than a weekend to bring it around...barring any valve damage (sounds like you're free and clear here)...but sight unseen going to....well have someone pull the timing cover off...then we'll talk...~

2 people found this helpful.
255

yeah i was afraid of that or a pcm which scares me to! but okay can do on that!!! will get back to you in a little bit heading down to it now. thanks

2 people found this helpful.
40,195

pull air cleaner check for water intake.jacks nocked loose,crank with wide open throttle

2 people found this helpful.

I disagree with my co-hort DO NOT run the engine at all until the sprockets have been put right/new timing chain installed, we don't want ANY more damage~

1 people found this helpful.
255

well when we go to try and start it we pump the gas and we can smell it from the engine, and we car gonna do a compression check tomorrow so after that we can go from that we can go to the timing chain!

3 people found this helpful.

okay jimmy m'boy was onto something Rockauto will just sell you the primary chain for cheap no tensioner and also the price is excellent- hat's off jim~

255

I kind of know about cars so I'm not all blonde my dad was a mechanic but jimmy i dont quite understand, (pull air cleaner check for water intake.jacks nocked loose) are you talking about the air filter part? and i dont quite know what jacks knocked loose is can you give me an idea please! thanks

2 people found this helpful.
255

Lol ohh Roy woman are to just we only do it when some one is messing with our family or man!

1 people found this helpful.
40,195

and do us a favor ,come back with what was the problem so we can learn something , bet your father would find these answers hilarious !

3 people found this helpful.
255

I will Jimmy, lol he would, he probably would already know the problem as he was a diesel mechanic and worked on chevys and fords and built race cars RIP dad miss you! No helper Roy kind of sucks I work 3-11 n have very little time to work on it till Saturday n Monday but its okay if I can't fix it I'll destroy it :) N PS not a flirt was just telling the truth about woman I am just open and very easy to talk to!!

177,695

"so we changed the cam sensor and it turns over not stopping just not starting the engine" --- the compression test will tell for sure but if it was a interference engine, it wouldn't turn over. The chain could have jumped a tooth but it ran normally for some time after the braking incident. --- It did have a flashing CEL so getting the codes read will tell you what system failed. It sounds like the ECU went into "limp mode" and that caused the restricted RPM's.

3 people found this helpful.
255

Haven't done test yet sorry! So if compression is good and I just jumped a tooth can it I just retime it? Or U said its in limp mode how do I get it out of it...Jimmy I don't know if that was suppose to be mean or good? I am very good and faithful to my bf soon to be fiancee but him on the other hand hasn't but this is not a place to talk about my life its about my Jeep that's being a ass!

1 people found this helpful.

compression would be crap, that's how we know one of your timing belts jumped a tooth...and if I were a betting man would say the others aren't far behind, but yes this fantasy of putting it right and NEVER ever again having a panic-stop, putting the mill out of commission is mere fantasy~

177,695

"So if compression is good and I just jumped a tooth can it I just retime it?" - You could but it would do it again. You would need to replace the chain and tensioner. If your chain jumped a tooth, it's worn out. -- It will leave limp mode when the engine is running right. The ECU enters limp mode to protect the engine and get you off the highway.

2 people found this helpful.
255

Thanks Roy and tenspeed!! I have never done a compression test on a newer car use to mustangs so IM having a friend come do it, hoping its tomorrow

1 people found this helpful.
255

Haven't done a compression check yet as still waiting for the guy to come over but I had my brothers friend come over and he said IM not getting no spark and my oil smells like gas?

80

It has been a long seven months. It was a very interesting story. I would love to know how it ended...

45

My 2003 jeep liberty was running fine until i noticed a oil smell wen i start the engine and today i went to do some erants then i make a last stop and wen i done my jeep wont start at all it sound like it needed gas so i put gas knowing that it dont need none but still put some still not starting, had to pull the jeep home and after and hour or so it starts great

4 people found this helpful.

Your Answer:

Liberty

Looking for a Used Liberty in your area?

CarGurus has 23 nationwide Liberty listings starting at $2,495.

Postal Code:

CarGurus Experts

  • #1
    rst429
    Reputation
    3,170
  • #2
    fixmyjeep
    Reputation
    3,030
  • #3
    Gene Arnett
    Reputation
    1,990
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Jeep Patriot
11 Great Deals out of 245 listings starting at $2,999
Used Jeep Wrangler
139 Great Deals out of 4,992 listings starting at $4,500
Used Jeep Grand Cherokee
109 Great Deals out of 3,136 listings starting at $3,995
Used Jeep Compass
66 Great Deals out of 3,828 listings starting at $1,693
Used Dodge Nitro
6 listings starting at $2,799
Used Jeep Commander
2 listings
Used Subaru Forester
28 Great Deals out of 1,325 listings starting at $2,295
Used Ford Escape
118 Great Deals out of 4,934 listings starting at $2,795
Used Ford Edge
88 Great Deals out of 2,066 listings starting at $2,950
Used Honda Accord
55 Great Deals out of 995 listings starting at $2,000
Used Honda Pilot
36 Great Deals out of 1,300 listings starting at $2,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.