Mazda 2001 626 2.0

Asked by KoolT Oct 18, 2016 at 01:35 PM about the 2001 Mazda 626 ES

Question type: Maintenance & Repair

I have a 2001 Mazda 626, 20 liter engine. I change the spark plug and wires on the car. it starts, but when the car is put into drive, it cut off. It will also start in (N) to, but will cut off when shifted into drive. I change the ignition coil and redid the plugs and wires, the same thing happen. What Is wrong?

1 Answer

189,445

It could be IAC valve. does the RPM's it fluctuate ? if so then you might have a vacuum leak. Check hoses and manifold gasket. It should remain constant @ approximately 700 - 750 rpms when warmed up. Or you may want to look at your throttle clean it real good with a throttle body cleaner. While you are there check the fuel pressure

1 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    littlehorn
    Reputation
    600
  • #2
    Gene Arnett
    Reputation
    280
  • #3
    Daniel Reed
    Reputation
    240
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.