My 1991 mazda 626 automatic is not selecting any gear i have checked the fluid levels and it is ok.Could there be a fuse blow or something like that since they are electronically controled?

25

Asked by Cam75 May 05, 2007 at 01:45 AM about the 1991 Mazda 626 LX

Question type: Maintenance & Repair

It is not selecting any gear (automatic) i have checked the selector on the gearbox and it is still working.Since they are electronically controlled are there any fuses that could be blown or could there be a sensor gone as the fluid level is ok?

LouB answered 17 years ago

Hi Cam75. If your fluid levels are solid then chances are that you'll need to see a professional to have your tranny looked at. Still, here's a link to a transmission troubleshooting guide to help you run down anything you might have missed. Hope it helps, good luck! http://www.procarcare.com/includes/content/resourcecenter/encyclopedia/ch21/21TSautotranny.html

4 people found this helpful.

Best Answer Mark helpful

Your Answer:

My 1991 mazda 626 automatic is not selecting any gear i have checked the fluid levels and it is ok.Could there be a fuse blow or something like that since they are electronically controled? 1 Answer

It is not selecting any gear (automatic) i have checked the selector on the gearbox and it is still working.Since they are electronically controlled are there any fuses that could be blown or could th...

1991 Mazda 626 LX

-

Maintenance & Repair
i have a 2000 mazda 626 lx. the knob to control the temperature swings freely from hot to cold without any form of resistance whatsoever. i assume its supposed to offer some form of resistance it i want to turn it from red(heat) to blue(cold), but it just swings freely. i think something must be broken. i tried to pull it out, but its hopeless. i don't want to break something else. the reason i'm asking this is because my heater is not working and this little problem might or might not be the reason. thanks for your help. 1 Answer

i have a 2000 mazda 626 lx. the knob to control the temperature swings freely from hot to cold without any form of resistance whatsoever. i assume its supposed to offer some form of resistance it i wa...

2000 Mazda 626 LX

-

Maintenance & Repair
i have a 200 mazda 626 just rebuilt the trans now if i put the shifter in low or revers it pulls but if i put it in 2nd or drive it dont and there is no codes 5 Answers

i got the care with the trans out of it i rebuilt it know it will pull in low and revers but it will not pull ot all if the shifter is in drive or 2nd there is not any codes in it and i dont think it...

2000 Mazda 626 ES

-

Maintenance & Repair
I have a Mazda 626 and it is overheating and when I put water into the radiator it won't fill up 1 Answer

I have Mazda 626 and it is overheating when the car is hot I put water into the radiator and it geysers out. When the car is cool and been standing some time it will not fill up, it just keeps runni...

2000 Mazda 626

-

Maintenance & Repair
I need help! I have a 1991 Mazda 626 1 Answer

I need help! I have a 1991 Mazda 626 It has a high idle when it gets warmed up. It runs perfect until then. You can smell gas. But it runs good on the highway. I took it for an emission Test and it fa...

1991 Mazda 626 DX

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.