I have two codes with my 01 mercury cougar p1744 & P0720

All this sounds like you can take care of shouldn't be too difficult. P0720 FORD - Output Speed Sensor Insufficient Input... Possible causes...> - Faulty Speed Sensor - Speed Sensor harness is open or shorted - Speed Sensor circuit poor electrical connection... When this code is detected, Vehicle speed sensor over 1 MPH while the output speed sensor signal did not agree Possible symptoms.. - Engine Light ON (or Service Engine Soon Warning Light) - Speedometer improper reading - Possible shifting problems P0720 Ford Description.... The speed sensor detects the revolution of the idler gear parking pawl lock gear and emits a pulse signal. The pulse signal is sent to the Transmission Control Module (TCM) which converts it into vehicle speed........ P1744 FORD - Torque Converter Clutch System Stuck in Off Position, Possible causes...> - Low transmission fluid level - Dirty transmission fluid - Faulty torque converter clutch solenoid valve - Torque converter clutch solenoid valve harness or connectors - Torque converter clutch solenoid valve circuit is open or shorted - Transmission internal mechanical problem... Tech notes, OBDII Code P1744... The Engine Control Module (ECM) detected excessive transmission slippage or no TCC solenoid operation Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light) P1744 Ford Description... The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter. Lock-up operation, however, is prohibited when A/T fluid temperature is too low. When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.