Hydraulic clutch line
Asked by Shellie May 22, 2020 at 10:13 PM about the 1998 Mazda B-Series B2500 SE RWD
Question type: Maintenance & Repair
I replaced the master cylinder as well as the clutch hose
and about 3 years ago replaced the slave cylinder but now
the clutch is sticking and when I press it too hard the
clutch hose pops out of the transmission. How can I fix
this?
3 Answers
beatupchevy answered 4 years ago
sounds like the little clip that holds the hose in is missing , your experience may differ
Its there but maybe it's worn it almost feels like air is building up
beatupchevy answered 4 years ago
If you have clutch problems don't drive it , you may ruin the tranny . Sounds like someone will be pulling that tranny , again