I have a 1990 nissan pickup my problems is i try to make the engine run and when i turn the key on nothing happens everything else works inside but the engine outside it dont make any sound..

Asked by Eric Jan 05, 2014 at 02:32 PM about the 1990 Nissan Pickup 2 Dr STD Standard Cab SB

Question type: Maintenance & Repair

200,965

dandyoun answered 10 years ago

Sounds like a loose battery connection. Clean and tighten all battery connections. Also clean and tighten the negative connection on the frame and motor. Test battery for full charge. If all that checks good but still won't crank test the starter. Also check that the solenoid is getting 12 volts to engage the starter. If it's not then check you clutch pedal switch or neutral safety switch (if automatic). Hope this helps

2 people found this helpful.

Mark helpful

Your Answer:

I have a 1990 nissan pickup my problems is i try to make the engine run and when i turn the key on nothing happens everything else works inside but the engine outside it dont make any sound.. 1 Answer

1990 Nissan Pickup 2 Dr STD Standard Cab SB

-

Maintenance & Repair
1990 nissan pickup try to make it run in i can...i get in turn the switch everything works find inside but the motor won't makena sound.. 1 Answer

Well everything goes good and works perfect inside but when i step on the clutch and turn the key to on nothing no sound of the motor

1990 Nissan Pickup 2 Dr STD Standard Cab SB

-

Maintenance & Repair
i have a 95 nissan hardbody the head lights will come on , but thats it nothing else works , 2 Answers

head lights come on , but nothing else works , have power to two fuses for the tail lights but that's it .

1995 Nissan Pickup 2 Dr XE Standard Cab SB

-

Maintenance & Repair
I have a 90 D21 pickup 5 speed 2x4. My problem is that it will crank, run idle and I can rev the engine but when I put it into gear it lose power, won't go 2 Answers

When I put my truck in gear it loses power and shuts off. I have redone my timing chain, replace my exhaust, tune-up, mass air sensor, O2 sensor, fuel pump and filter, and distributor. I still have th...

1990 Nissan Pickup 2 Dr STD Standard Cab SB

-

Maintenance & Repair
I have an 87 D21 Nissan truck it will start and run but just a second then stop firing you can leave it over night and it will crank again. I have changed the coil got the same thing. I checked the voltage to the coil with switch on its 12.95 volts when turning over it goes down to 9.5 volts. any suggestions ? 5 Answers

I have an 87 D21 Nissan truck it will start and run but just a second then stop firing you can leave it over night and it will crank again. I have changed the coil got the same thing. I checked the vo...

1987 Nissan Pickup

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.