Check to make sure the starter is not loose and the bolts are tight.
Thank you,for the quick response . I replaced the starter motor with a remy starter motor.The starter motors from discount auto parts store are junk & made in china.The flywheel teeth where missing 75 % on 4 teeth. The engine starts for now,but is a little noisy,because of the missing teeth on the flywheel. Hopeful I can get 1-2 years from the chewed up flywheel ,before i buy a new van.
starter noisy when cranking
2006 Ford E-Series E-250 Cargo Van
-
Maintenance & Repair
I have a 2007 Ford E-250 van and I was wondering where the fuel module was located for repairs
2000 Ford E-Series E-350 Cargo Van
-
Maintenance & Repair
Hi. I w as cleaning our church van yesterday. I noticed up underneath the van where support bars meet and screw(possibly where the seats screw in) there was some rust. I am concerned that it will g...
2000 Ford E-Series E-350 XL Passenger Van
-
Maintenance & Repair
Just filled the 36 gallon gas tank, and drove it home. Now it doesn't start. Spray starting fluid into the air filter, and it runs for a few seconds. The fuel pump fuse and relay are good, and when...
1997 Ford E-Series E-150 STD Econoline
-
Maintenance & Repair
need to change the fuel filter on my 1996 E-250 cargo van and cannot get the clips loose
1996 Ford E-Series E-250 3 Dr STD Econoline Cargo Van
-
Maintenance & Repair
CarGurus has 142 nationwide E-Series listings starting at $2,495.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.