2x2 in 4x4 ttuck
Asked by jimboledford1958 Mar 08, 2019 at 05:07 PM about the 1996 Ford Ranger STX Standard Cab 4WD SB
Question type: Maintenance & Repair
I have. 96 ranger 4x4. An the rear end is
bent. I found one outta another truck that
2x2.... the axle code is the same (86). Will
this rear end bolt up an work? Or would I
have to get the front Axels an make mine
2x2.
3 Answers
jimboledford1958 answered 5 years ago
If the gear ratio is different I could just change front Axels as well and it should be fine? Even didn't it would work just not run like it should correct?
jimboledford1958 answered 5 years ago
Ok so if it is,. Just remove front driveshaft. An basiclyy make the truck 2 wheel drive until I found one geared the same ? Been on the look for a year now an no luck with a open 7.5, 373, with 9 inch drum brake.....
jimboledford1958 answered 5 years ago
I'm just going to. Change the 3rd member an shim it.....just the housing outta the 2 wheel drive....thanks for the info