2001 Montana - What should be the length of the passenger's windshield wiper?

385

Asked by billybob567 May 03, 2013 at 08:34 AM about the 2001 Pontiac Montana Base Extended

Question type: Maintenance & Repair

I've had this problem for a while where my wipers catch on each other and then get twisted. I've tried adjusting their off position with no luck. I just changed the whole assembly thinking the motor or linkage was worn out. Problem still happens. I noticed that after I ran the wipers and then turned them off, the passenger side was not resting against it's bumper. It was stuck on the molding around the bottom of the windshield. The edges of the wiper appear to be ~1/2" too long on each end and catch. I measured the wiper length and its 24". The same wiper on my 2003 montana is 23" long. I checked the web and the wiper is spec'd at 24".

Has anyone else run into this problem and found the work-around?
Thx.

1 Answer

177,695

Try the 23" wiper from the Montana and see if that work better. An inch shorter isn't going to make that much difference in the wiping area. -- Tom is right about removing the arm and repositioning. The problem is that they are almost impossible to remove after a few years of corrosion.

Your Answer:

CarGurus Experts

  • #1
    Countrygal77
    Reputation
    2,930
  • #2
    Robert Reed
    Reputation
    2,030
  • #3
    DaveG
    Reputation
    1,090
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.