Feul system ford bantum rocam enjin 1.3

Asked by Guru9DTTK1 Oct 31, 2020 at 02:36 PM about the 1995 Ford Bantam

Question type: Maintenance & Repair

Hi i have a ford bantum 1.3 rocam enjin, i have replaced the
feul pump and the fuel intake line from the feul tank to the
injectors but now when i drive the vehicle jurks and a
strong smell of fuel coming out of the exhaust, the
replacement feul line is a bit bigger than the original, how
can i fix the problem.

1 Answer
16,945

Guru97FK8 answered 4 years ago

Check for a damaged fuel return pipe from the injectors to the fuel tank. If the reurn line is damaged or squashed , this creates extra pressure at the injectors. Check also the fuel pressure regulator. Check the spark plug gaps. Should be 1.00mm Gap.

1 people found this helpful.
Best Answer Mark helpful

Your Answer:

Related Questions

  • Feul system ford bantum rocam enjin 1.3 1 Answer

    Hi i have a ford bantum 1.3 rocam enjin, i have replaced the feul pump and the fuel intake line from the feul tank to the injectors but now when i drive the vehicle jurks and a strong smell of fuel...

    1995 Ford Bantam

    -

    Maintenance & Repair

  • Ford bantum rocam 1.3 2 Answers

    My ford bantum rocam gives on but does not want to start or even crank the engine,what l noticed again the is a small red light near the watch that switches on when l turn on the car then off and ...

    Ford Bantam

    -

    Maintenance & Repair

  • Ford Bantum 1.3 rocam 2 Answers

    Hi, my motor has been completely redone. I'm driving it for a couple of weeks. When I get to about 2000rpm it started misfiring and it is getting worse, this afternoon it was misfiring badly and the...

    Ford Bantam

    -

    Maintenance & Repair

  • Bantam 1.3 Rocam feul problem 1 Answer

    My bantam doesn't start when it is warm, it also does not get feul at the injectors in front. We replaced the feul pump and the cranck sensor, but it still does the same? Any suggestions?

    1995 Ford Bantam

    -

    Maintenance & Repair

  • Ford Bantum 3 Answers

    I have a Ford Bantum Rocam 1.3 it’s doesn’t want to rev but ones I remove the plug for the map sensor it revs and black smoke coming from the exhaust please help what’s wrong with my car

    Ford Bantam

    -

    Maintenance & Repair

Shortcuts

Search Ford Bantam Questions

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,630
  • #2
    MrRocket12
    Reputation
    1,150
  • #2
    Janus Welgemoed
    Reputation
    1,150
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.