how do i get my car to run?

Asked by BigJohnson Oct 31, 2010 at 03:40 PM about the 1988 Subaru GL

Question type: Maintenance & Repair

i tried to do a tune up on my 88' gl sedan. i changed the plugs wires and distributer cap.  after completing this i tryed to start my car and it wouldnt start. after further investigation i noticed  that it was getting gas to cylinders 2 and 4 but had no gas in 1 or 3.

1 Answer

Rent or borrow a fuel pressure gauge. Also, I have two of these cars and earlier this year one would not start. Since it had just been run the night before I knew it had to be something simple or very apparent. I pulled off the throttle control switch connection and low and behold .....corrosion!! A little WD-40 and it fired right over. It was a bugger to get off though. This sits to the right of the throttle-body . Conact me if this helps, toddcrhoads@yahoo.com

Your Answer:

CarGurus Experts

  • #1
    korean
    Reputation
    150
  • #2
    Alex Nicolaou
    Reputation
    90
  • #3
    tenspeed
    Reputation
    80
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.