Asked by sirbangalot Jan 22, 2013 at 03:25 PM about the 1999 Ford Expedition
Question type: Maintenance & Repair
BearWalker answered 11 years ago
Put 12 volts directly to the motor. If it works your motor is fine. Probably a circuit issue... broken wire or blown fuse/ bad relay. Make sure motor body is properly grounded to vehicle body.... mount contact points clean...
1999 Ford Expedition
-
Maintenance & Repair
I have a 2000 ford expedition 4WD 5.4L triton motor I put a new starter solenoid and new battery and cables on it and still just making a single clicking noise any suggestions
2000 Ford Expedition XLT 4WD
-
Maintenance & Repair
2004 Ford Expediton Eddie Bauer Edition. The radio stopped working, and changed the fuse, but maybe it needs something else. Please help..
2004 Ford Expedition Eddie Bauer 4WD
-
Maintenance & Repair
Left rear blinker and brake light is out. Changed bulbs, housing, and now put in new signal/hazard unit. Still not working
2004 Ford Expedition Eddie Bauer
-
Maintenance & Repair
Last night the expedition died on my wife. I got it running again and it ran fine and then all the sudden the motor would run poorly, The dash went crazy speedometer pegged out and back 0mph, the m...
2012 Ford Expedition EL Limited
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.