Read the codes again and post them here. Post the actual numbers.
P0108 could be a bad MAP sensor. The P0113 could be a bad air intake temperature sensor or damaged wires going to the sensor. This issue could be the real culprit that put your car in limp mode. Look up the codes for other possible explanations.
My is in limp mode I put it on a machine it read the crankshaft sensor and the map sensor I changed them both n reset the codes n it's still in limp mode
2009 Dodge Charger
-
Maintenance & Repair
I have a 2006 dodge charger r/t, for some reason it stoped working! It had power but not start! So i took it to my mechanic, he couldnt fine anything, gas pomp good, oxigen sensors new, ingectors...
2006 Dodge Charger R/T RWD
-
Maintenance & Repair
2006 R/T charger. 78000 orig mi. Check engine light. Went into limp mode..brought to my mechanic... (no codes showing for him) .Replace fuel pump 6 months ago.. light came on intermittently... then ...
Dodge Charger
-
Maintenance & Repair
I left my house like Arthur Define set the gas station started crying went to my friend's house went to leave for a half hour later start it up put it in reverse it shut off I had it towed change m...
2007 Dodge Charger R/T AWD
-
Maintenance & Repair
mechanic checked car told me it showed a code 62, checked vic motor and removed to find plastic worm gear behind from plenum to be worn. was told i needed to replace plenum and possibly vic motor. d...
1993 Dodge Stealth R/T FWD
-
Maintenance & Repair
CarGurus has 607 nationwide Charger listings starting at $4,888.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.