How do I clear the SERVICE TRAILER BRAKE SYSTEM alarm?
Asked by Megawatt Aug 21, 2013 at 09:39 PM about the 2010 Dodge RAM 2500
Question type: Maintenance & Repair
My battery was weak and truck would not start (had inside lights and dash lights). i
charged battery and truck started has run fine since then. Every since the charge there
has been an message with a pic of trailer with line through it.
5 Answers
migration_judge_roy answered 11 years ago
Isn't there supposed to be a "terminator" on the trailer pigtail, so crud does not get into the connection?
migration_judge_roy answered 11 years ago
here's an absolutely worthless forum on the subject...in short check your fuses~
migration_judge_roy answered 11 years ago
http://www.dodgetalk.com/forums/showthread.php?t=333595
All fuses are good !
migration_judge_roy answered 11 years ago
you could try the old standard pull the negative cable for fifteen seconds and replace, after first discharging any latent electrical devices~
