It doesn't sound or fel like enough fuel is getting to th engine, causing hitchig and sputtering. What should I do? I'm 12 hrs from home
car overheated so thermostat was replaced
has not run smoothly since (yesterday)
migration_judge_roy answered 11 years ago
is this a DOHC engine? are you limping along on one camshaft wacko? Obviously you've melted something, we have to find out what that is~
migration_judge_roy answered 11 years ago
you may have a fuel pressure problem...disconnect the vacuum hose to the fuel pressure regulator and note any change in speed~
car overheated so thermostat was replaced has not run smoothly since (yesterday)
2003 Jeep Liberty
-
Maintenance & Repair
My 2005 Jeep Liberty is getting wet on the driver side on the floor I don't know why what should I do
2005 Jeep Liberty Limited
-
Maintenance & Repair
The original camshaft sensor has been misplaced that is why we have tried many others but the same type but it still does not start the vehicle.
2002 Jeep Liberty Limited 4WD
-
Maintenance & Repair
once i'm on the highway going a certain speed my car will start to decelerate while i'm still pressing on the gas pedal, and the rpm will just race. then when it hits between 50 and 60 it will st...
2007 Jeep Liberty Limited
-
Maintenance & Repair
I have a 2002 Jeep Liberty that has about 136,000 miles on it. It has received every required servicing including and oil and filter change every 3600 miles. Right now, between servicings I have t...
2002 Jeep Liberty Limited 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.