I JUST BOUGHT A ORIGINAL 74 Z-28(1974)(4 SPEED TRANSMISSION) ,IT WAS FACTORY ORDERED IN 1973,ANYWAY WHERE CAN I FIND REVERSE ON IT..I HAVEN'T DRIVEN CAR YET AND AS WELL MY KEY IS STUCK IN THE IGNITION, THANKS IF ANYONE CAN HELP...

Asked by duoverman Sep 01, 2007 at 11:37 AM about the 1974 Chevrolet Camaro

Question type: Maintenance & Repair

1974 Z-28 FACTORY 4 SPEED, WAS ORDERED IN 1973 ,HAS POINTS IGNITION

hAVE NOT DRIVEN CAR YET AND I'M STILL LOOKING FOR WHERE IS THE REVERSE GEAR ON IT...EXAMPLE IS IT LOWER RIGHT BOTTOM..SO FAR I CAN ONLY FIND 1,2,3,4 GEARS......MY KEY IS STUCK IN THE IGNITION..FROM WHAT I UNDERSTAND TO GET KEY OUT, THE SHIFTER HAS TO BE PLACED IN REVERSE FIRST... THANKS IF ANYONE CAN HELP

ONE MORE QUESTION, I BOUGHT THIS CAR OFF THE ORIGINAL OWNER,SHE CLAIMS ITS ALL ORIGINAL BUT I WAS SURPRISED TO SEE A HOLLEY CARB ON IT,IT LOOKS VERY CLOSE TO THE QUADREJET CARB. LOOKS LIKE ORIGINAL MAYBE 6,7 OR 8 FACTORY VACUM LINES OR SIMERLAR AND ALL SEEM TO BE IN PLACE WHERE THEY ALL EXECT...I DO KNOW THAT WHEN SHE FACTORY ORDERED THE CAR ,SHE WANTED SPECIFIC ITEMS ON THE CAR AND OTHER ITEMS NOT TO GO WITH THE CAR..ANYONE KNOW ANYTHING ABOUT THIS HOLLEY.... THANKS

195

ghostrider answered 17 years ago

From the Camaro's and TA's I have drivin' in the '70's, reverse is to the left and up, it also cause's a part in the steering column to turn, as you put it in Reverse.If the linkage or syncro's are beat up, you may have to look for a "sweet spot. If no luck, try turning the steering column safty... scott

1 people found this helpful.

Mark helpful

duoverman answered 9 years ago

Thanks for your response, you are correct. good advice!

Mark helpful

Your Answer:

I JUST BOUGHT A ORIGINAL 74 Z-28(1974)(4 SPEED TRANSMISSION) ,IT WAS FACTORY ORDERED IN 1973,ANYWAY WHERE CAN I FIND REVERSE ON IT..I HAVEN'T DRIVEN CAR YET AND AS WELL MY KEY IS STUCK IN THE IGNITION, THANKS IF ANYONE CAN HELP... 2 Answers

1974 Z-28 FACTORY 4 SPEED, WAS ORDERED IN 1973 ,HAS POINTS IGNITION hAVE NOT DRIVEN CAR YET AND I'M STILL LOOKING FOR WHERE IS THE REVERSE GEAR ON IT...EXAMPLE IS IT LOWER RIGHT BOTTOM..SO FAR I CAN ...

1974 Chevrolet Camaro

-

Maintenance & Repair
i have a 94 camaro 3.4 v6 the motor is basically shot after have 200k miles on it but i came across some body that has a carberated 305 i was wonderin if i could switch out my 3.4 v6 for the 305 and keep the transmission the same since i just got a new1 and if i can wat snags would i come across 2 Answers

i have a brand new tranny and so forth i was wondering if i would have to part out my old motor change the mounts and so forth any info or tips would be much appriciated

1994 Chevrolet Camaro Coupe RWD

-

Maintenance & Repair
I have a 1989 Camaro RS V6. On my way home from work yesterday I noticed that all my guages are floating the speedometer was bouncing around between 60 and 70 sporadically. The temperature gauge, oil gauge, rpm and gas gauge were all floating around when I slow down they all start coming back down? For just a second I smelt a very strong burning smell (electrical) that very quickly faded. The SES light has been on constant the whole time this is happening. Same thing was happening on the way to work this morning car is running and driving just fine. I guess today when I get home I can check the codes to see what codes I get as a starting point and work my way from there. I will also check the ground wires to see if maybe I am not getting good connection somewhere. Could it be my battery by chance? Maybe even a stripped wire somewhere?Any help would be greatly appreciated. Thanks! 4 Answers

I know the best advise would be taking it to a mechanic, but I do not have the funds for that they raped my wallet just a little over 2 months ago and now I am the only one working so there is just no...

1989 Chevrolet Camaro RS Coupe RWD

-

Maintenance & Repair
Please, I would like to know where is located the VATS module in a 1999 Camaro. I have problem with the PASS II Key system. I changed the cylinder lock and the key, but the car starts not always. 2 Answers

I have problems wuth the PASS II Key System. I changed the ignition switch cylinder and bought a new key. I still have the same problem. The car only start in some ocassions. If I leave the key in...

1999 Chevrolet Camaro

-

Maintenance & Repair
i just put a new wiring harness in my car and i can get the doors to open and close for the headlights can anyone help me 1 Answer

I got a new wiring harness for this car and now i can not get the doors for the headlights to open and close

1967 Chevrolet Camaro

-

Maintenance & Repair

Used Ford Mustang

60 Great Deals out of 1,365 listings starting at $4,995

Used Chevrolet Corvette

22 Great Deals out of 1,084 listings starting at $15,000

Used Dodge Charger

39 Great Deals out of 727 listings starting at $5,995

Used Dodge Challenger

22 Great Deals out of 455 listings starting at $7,999

Used Ford F-150

320 Great Deals out of 13,991 listings starting at $1,712

Used BMW 3 Series

64 Great Deals out of 1,232 listings starting at $2,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I JUST BOUGHT A ORIGINAL 74 Z-28(1974)(4 SPEED TRANSMISSION) ,IT WAS FACTORY ORDERED IN 1973,ANYWAY WHERE CAN I FIND REVERSE ON IT..I HAVEN'T DRIVEN CAR YET AND AS WELL MY KEY IS STUCK IN THE IGNITION, THANKS IF ANYONE CAN HELP...

2 Answers

Your Answer:

Shortcuts

Search Chevrolet Camaro Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

I JUST BOUGHT A ORIGINAL 74 Z-28(1974)(4 SPEED TRANSMISSION) ,IT WAS FACTORY ORDERED IN 1973,ANYWAY WHERE CAN I FIND REVERSE ON IT..I HAVEN'T DRIVEN CAR YET AND AS WELL MY KEY IS STUCK IN THE IGNITION, THANKS IF ANYONE CAN HELP...

2 Answers

Your Answer:

Related Questions