think i may have a tranny problem?

15

Asked by 4x4girl89 Jul 18, 2011 at 11:07 PM about the 1988 Ford Bronco II

Question type: Maintenance & Repair

first start off goes to 1st 2nd. and then rpms goes high and hesitates to go to 3rd and 4th. into overdrive. it wont go into reverse either. im running out of options im not selling my truck. i love it but i want it fixed. in order for it to drive kinda good i have to manually shift it. its a automatic any ideas or advice for me.

klcair99 answered 12 years ago

The clutches are worn out. Best bet is a rebuild or an exchange of a refurbished tranny. Check around and make sure the shop you select has a good reputation.

Mark helpful

papa answered 12 years ago

agreed with other poster,another option is to get one fron a salvage yard.

Mark helpful

Your Answer:

think i may have a tranny problem? 2 Answers

first start off goes to 1st 2nd. and then rpms goes high and hesitates to go to 3rd and 4th. into overdrive. it wont go into reverse either. im running out of options im not selling my truck. i love i...

1988 Ford Bronco II

-

Maintenance & Repair
Hey guys, i have a 1985 Bronco II, 2.8L, XLT. There is a hose that is missing from the side of my air filter housing that leads to the front of the vehicle. I have searched high and low for this replacement hose. I think my biggest problem is that I do not know what the part is actually called. Does anyone know what this part would be called? Thanks, upfront, for the help. 5 Answers

Hey guys, i have a 1985 Bronco II, 2.8L, XLT. There is a hose that is missing from the side of my air filter housing that leads to the front of the vehicle. I have searched high and low for this rep...

1985 Ford Bronco II XLT 4WD

-

Maintenance & Repair
O.K, I have a problem that has all the wizards I know {limited, but they try} scratching their heads, Bought a 1988 Bronco 2 2.9, 5sp. 13 Answers

the Bronco 2 was going start, no start intermittently for some time for the previous owner, He drained fuel and parked it., I picked it up for $300.00 for something to mess {haha,} with, first off f...

1988 Ford Bronco II XL 4WD

-

Maintenance & Repair
I have a bronco 2 aoutmatic and I been having a problem going forward. I put some transmission fluid in and when I put it in drive, the gear doesn't work? Anyone know why? 6 Answers

I have to touch the gas for a little bit ll I feel it go into drive

1988 Ford Bronco II XL

-

Maintenance & Repair
I have a 88 Bronco II that won't start 5 Answers

I have replaced a starter (burned-up) , start solenoid (old one stuck on), start switch.....after all this ....solenoid gets stuck on ....stays on after switch is turned off, even after ignition wire ...

1988 Ford Bronco II Eddie Bauer 4WD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.