twistedwankel answered 10 years ago
Then all that's left is the hot wire going to ground and shorting out. You'll have to follow the harness all the way back looking for rubbing or corrosion. Exposed all the way from the cab to back under the bed so look for corrosion or rubbing. At night you can look for sparks while someone puts in a new fuse?
replace stop light switch, bulbs and everything good. burns the fuse.
1998 Chevrolet C/K 1500
-
Maintenance & Repair
sounds like brake switch is working fures and blubs all ok.
1998 Chevrolet C/K 1500 Silverado Extended Cab 4WD
-
Maintenance & Repair
The brake lights work when the trailer brake is used. Wont work when break pedal is depressed. I look at the switch on the break pedal it is working fine. Looked at all fuses and relays. Not sure ...
Chevrolet C/K 1500
-
Maintenance & Repair
i just got a 94 chev pickup and all brakes lights don't work! I have checked the fuse which is goo, and the brake switch and that doesn't seem to work, anything else?
1994 Chevrolet C/K 1500 WT 4WD
-
Maintenance & Repair
There is no ground single coming from the ecm to the injectors. I have replaced the ecm and throttle position, air idle, and map sensors. I also checked the ground wires and cleaned the conections.
1992 Chevrolet C/K 1500 Scottsdale Extended Cab RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.