Asked by 96_gmcSIERRA_1500 Mar 20, 2015 at 11:11 PM about the 1996 Chevrolet C/K 1500
Question type: Maintenance & Repair
If stopped the only way to keep it
running is to keep the engine revved.
Throttle positioning sensor located on the throttle body or on the breather depending on which model you have
blackpanther answered 9 years ago
Hm, maybe vacuum leak? I would check for that because if it stalls at idle but runs fine when revved, I would check for a vacuum leak first thing.
If stopped the only way to keep it running is to keep the engine revved.
1996 Chevrolet C/K 1500
-
Maintenance & Repair
Have tried egr, coil, ignition relay, abs, check for vacuum leaks, rotor and cap, distributor, fuel pressure and it has a new alternator and battery
1995 Chevrolet C/K 1500 Silverado Stepside RWD
-
Maintenance & Repair
I have a brand new sending unit and fuel pump and there is plenty of fuel pressure and spark cause if I take some starting fluid and spray it into the throttle body it will run fine, I'm stumped ...
1998 Chevrolet C/K 1500 Cheyenne Extended Cab RWD
-
Maintenance & Repair
1993 Chevy Cheyenne rough idleing and dies unless I throw it into netrual
1993 Chevrolet C/K 1500
-
Maintenance & Repair
I have a 1988 Chevy truck 5.7 just recently it just shut off while I was driving it. it would start right back up and idle a few seconds and die again and this would go on for awhile. then sometimes i...
1988 Chevrolet C/K 1500
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.