When I have my high beams on it will start flashing from high beams to daytime lights. Unless I put the low beams on and it will stop and wont flash. Is it a short?

When I have my high beams on it will start flashing from high beams to daytime lights. Unless I put the low beams on and it will stop and wont flash. Is it a short? 3 Answers

Have a 1996 Chevrolet S10 4x4, low beams head lights work, but high beams will not work, how do we fix this? 2 Answers

we also got a fault code: P0102: Mass or Volume Air Flow Circuit Low Input How do we fix this? Thanks

I have a 1987 Chevy Pickup with a crate engine. I start it and it runs for about 15 -20 seconds and then shuts off. I have replace the air intake hoses, fuel lines, fuel filter. When it was turned on then started to idle low i dumped gas into it and it shut off immediately. Could it be getting too much gas? Would that mean the carb is clogged possibly? 4 Answers

I have a 1987 Chevy Pickup with a crate engine. I start it and it runs for about 15 -20 seconds and then shuts off. I have replace the air intake hoses, fuel lines, fuel filter. When it was turned ...

Chevy S-10 Extreme, year 2000. I have no daytime running lights or Low Beams.. 4 Answers

I replaced a Relay Switch, so now have Daytime Running lights, but still no Low Beams. Is there another Relay Switch in the box marked Fuses.. that I can replace to fix this problem?

Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from under the truck.I looked around and couldn't see anything visibly wrong.I started it up again just fine and started rolling in 1st gear, then I tried to shift to 2nd the truck just stopped and wouldn't go into any gear.At this point the truck will start but when I let the clutch out, it dies(in neutral). Had to remove my drive shaft to be towed on towrope because it wouldn't roll smooth in neutral. When the engine is running now I don't feel any vibration through the gearshift anymore like how I used to before it broke down. What could it be? 3 Answers

Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from...