littlehorn answered 17 years ago
Did you measure resistance of each wire to see if it is within specification? There could be other issues like a broken valve spring, perhaps a sensor that has gone bad (crank position sensor can make a bad miss), etc. Have this diagnosed by a competent mechanic as there are more than a few solutions that could be causing your problem.
miss like a bad plug or wire check both plug and wires ok
1996 Toyota Tacoma
-
Maintenance & Repair
My motor went out and I was told that my crankshaft was broken. Is it better to get it fixed or get a new motor? If a new motor, where can I search to buy another motor
1998 Toyota Tacoma 2 Dr SR5 4WD Extended Cab SB
-
Maintenance & Repair
Wrecked o5 6cylinder at 60 mile an hour pushed drive train back and over 2 inches would you think the motor has internal damage. Fan was smashed between radiator and front end. Broke one motor mou...
2005 Toyota Tacoma 2 Dr PreRunner Standard Cab SB
-
Maintenance & Repair
the motors are the same one is automatic the other is manual the manual has the bad motor can i swap the motors around.
1995 Toyota Tacoma V6 Xtracab RWD
-
Maintenance & Repair
Toyota
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.