I hav a 85 ford ranger that i have taken the distributor out with out marking where the rotor was at or anything now i put the timing marks where they are supposed to be and it wont start What do i do

Asked by David Apr 27, 2016 at 01:28 PM about the 1985 Ford Ranger

Question type: Maintenance & Repair

223,905

Rowefast answered 8 years ago

Need to bring #1 piston up on the compression stroke to TDC. Then you drop the distributor in place with the rotor pointing to #1 spark plug. Start it up by moving the distributor if need be to get it started, let it warm up and re-time it with a timing light.

1 people found this helpful.

Mark helpful

Your Answer:

I hav a 85 ford ranger that i have taken the distributor out with out marking where the rotor was at or anything now i put the timing marks where they are supposed to be and it wont start What do i do 1 Answer

1985 Ford Ranger

-

Maintenance & Repair
my truck was working fine yesterday(1995 ford Ranger 4.0l automatic i did an engine oil change with royal purple and K&n filter and after i got done i backed it out of the garage fine and then i put it into drive and it wouldnt move. after a while i tried to push it then it kicked into gear and now I have to do that every time I want to go forward. please help 4 Answers

my truck was working fine yesterday and I did an engine oil change with royal purple and K&n filter and after i got done i backed it out of the garage fine and then i put it into drive and it wouldn...

1995 Ford Ranger

-

Maintenance & Repair
I have a 96 Ford ranger, 4 cylinder manual and have a problem I can't figure out. I can start the truck every time with no problem it isles great and I can sit there and rev it all day no problem but if I go to drive it I can make it about 1/2 mile and then that's it, ill press the gas petal and it won't do any thing but kill the gas (no gas) but soon as I take my foot off the gas it will idle just fine and rev fine but won't go anywhere unless I let it sit for a few mins and it will start all over. I have replaced the IAC, TPS and today the external fuel filter that was clogged but same thing. Once in a while if I push the clutch in it will stay at a rev for a sec. Please help 5 Answers

96 Ford ranger need help :(

1996 Ford Ranger XL Standard Cab SB

-

Maintenance & Repair
I have a 2000 ford ranger in perfect condition, 37,000 mi. I have been smelling anti freeze lately and can't find out where the problem is. any info would be appreciated, my e-mail is baha151@aol.com 8 Answers

I have a 2000 Ford Ranger in perfect condition, 37,000 mi. I have been smelling anti freeze lately and can not found where the problem is, any info would be appreciated. my e-mail is baha151@aol.com

2000 Ford Ranger XLT Standard Cab SB

-

Maintenance & Repair
how do i locate the blower to change a resistor on a 2004 ford ranger 4 Answers

2004 ford ranger the blower only blows on high I was told to change a resistor but where do I find that

2004 Ford Ranger 2 Dr Edge Standard Cab SB

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.