Asked by Tyler_limberhand94 Jan 31, 2017 at 06:23 PM about the 2001 Chrysler Town & Country
Question type: Maintenance & Repair
It cranks over but don't want to start I
replaced the fuel pump the crankshaft
spencer and the coil PAC
Tyler_limberhand94 answered 7 years ago
But does any one know were the shut off switch is at
It cranks over but don't want to start I replaced the fuel pump the crankshaft spencer and the coil PAC
2001 Chrysler Town & Country
-
Maintenance & Repair
replaced the map sensor on this vehicle per the P106 and P107 codes at autozone and on the odometer, and it still runs like crap, barely runs, and still showing the same codes????? any ideas? thanks T...
2001 Chrysler Town & Country
-
Maintenance & Repair
I have a 2006 Chrysler Town and Country V6 3. 3 l. I tried to start it and it would start and kill immediately. It did this three times before I went to get my husband. He started it and it killed...
2006 Chrysler Town & Country FWD
-
Maintenance & Repair
My 2002 town and country turns over , but won't start. I took one spark plug out, set it on the engine to see if there was a spark, went to try to start and it did. Put the spark plug back in and i...
2002 Chrysler Town & Country
-
Maintenance & Repair
My 2001 Chrysler Town and Country has 2 cylinders that aren't firing have already changed the coil pack plug wires and sparkling plugs and still has a miss fire.?
2001 Chrysler Town & Country
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.