Asked by graciemarie1684 Aug 17, 2014 at 09:02 PM about the 1998 Dodge RAM 1500
Question type: Maintenance & Repair
THEN TRUCK WONT RUN RIGHT UNLESS YOU THROMP ON GAS PEDDLE ONCE YOU GET GOING ITS FINE , RUNS LIKE A BEAR, IT ONLY DOES IT WHEN YOU FIRST PULL OUT , LIKE ITS DYING OUT UNTIL YOU REALL HIT GAS PEDDLE HARD! ANY ANSWERS??? THANKS
THEN TRUCK WONT RUN RIGHT UNLESS YOU THROMP ON GAS PEDDLE ONCE YOU GET GOING ITS FINE , RUNS LIKE A BEAR, IT ONLY DOES IT WHEN YOU FIRST PULL OUT , LIKE ITS DYING OUT UNTIL YOU REALL HIT GAS PEDDLE HA...
1998 Dodge RAM 1500
-
Maintenance & Repair
I have replace the ECM computer, crank sensor , spark plugs, spark plug wires,
1994 Dodge RAM 1500 LT LB RWD
-
Maintenance & Repair
The noise is like a "tinny rattling exhaust" sound like used to come from exhaust heat risers that were used in older vehicles. The sound goes away after about 5 minutes when it warms up. It has 110...
2005 Dodge RAM 1500 SLT Quad Cab 4WD
-
Maintenance & Repair
I turn the truck off and restart it and the gauge works fine. Any ideas?
2004 Dodge RAM 1500 SLT Quad Cab 4WD
-
Maintenance & Repair
I have a 2002 Dodge Ram 1500 4x4 4.7 Sport. I recently put in a new/used motor because my old one had a bad crankshaft. So after many hours of getting new motor in, I started the truck and it ran gr...
2002 Dodge RAM 1500 ST Quad Cab LB 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.