My car did not shift the gear neither at D nor at 1,2,3 position Initially, after some time it works properly

First make sure that you are not low on transmission fluid. Usually, if it won't go into gear until you rev it up, that means it's low on fluid. If you have plenty of fluid, your Pressure Shift Solenoid on the transmission could be faulty. If you have never checked the level of transmission fluid before, you have to pull the stick with the vehicle hot and running. It's not like checking the oil. If it's low on the stick, you also have to have a special transmission fluid funnel to stick into the sleeve that you pulled the stick from.

I am having this same trouble with the transmission levr indicator stuck on reverse and the lever just feels loose when I move it up and down. It does not engage any gears at all. Anyone know the problem and possibly the needed repair.

A failed shift solenoid, or shift lock solenoid. Sounds like a needed trip to the transmission shop. Here's a link to your problem. http://www.ehow.com/list_7460536_symptoms-bad-transmission- solenoid.html

2007 chevrolet truck uplander after driving changing gear manually doesn't work on drive?

Unfortunately when an automatic starts acting up like that, it usually means it's time for a rebuild. You can try dropping the transmission pan, cleaning the filter and putting in new fluid. Odds are, it will need some major work. I checked consumer complaints and it's not uncommon for that year Uplander to have tranny issues around the 100k mark.

MINE JUST DID THE SAME THING. THE TRANSMISSION SHIFT CABLE BUSHING IS BAD WHEN THIS HAPPENS. I ORDERED A GOOD ONE FROM BUSHING FIX.COM FOR $20. YOU CAN GO To ADVANCE AUTO, NAPA OR ORIELLYS. DONT GIVE YOUR MONEY TO ANTI FREEDOM AUTO ZONE. TAKE 2 15mm BOLTS OFF HOLDING THE SHIFT CABLE DOWN AND YOU HAVE PLENTY OF ROOM TO WORK ON IT.

I can't drive my 2006 Chevy Uplander in Drive or in 3 I can only drive in 2 and 1 and it's like driving like a stick shift I can also reverse I put 2 quarts of transmission fluid in so now I'm just waiting my options what should I do next... Fix/junk

well i have an 2007 chevy uplander and i cant move when put it in d it wont move it want to move but something is keepin it from moveing somebody told me that its my transmission then somebody told me its not the transmission its the torque converter soenoid so i brought that and going to try this and see it it work but when my onstar did an diagnostic for it it just give me codes p0036 p0054 po141 p0442 so i dont what to do at this point

Make sure your parking brake is not on. Also make sure it’s not froze up.

I have a 2008 Chevy Uplander that when you put it in drive it don't want to go if you put it in reverse it works fine but you jack it up off the ground and everything shifts out fine this is all after I took it completely out and rebuilt it could it be the drive hubs

This me

My 2006 chevy uplander won't drive in zlD but will drive in 2 or 1 what could that be

No answer it running 70 mile p/h when ti stop

Simple anser could be shift cable bushing or the lower end disconnected from the transmission. Look down the.cable from the fire wall to the xmission.