i changed the calipers on my 07 sebring and still no brakes

Asked by mater2013 Sep 16, 2014 at 12:10 PM about the 2007 Chrysler Sebring

Question type: Maintenance & Repair

changed the calipers and bleed them and still no brakes

144,885

T_S_T answered 10 years ago

If you have bled the correctly,may be bad master cylinder.

Mark helpful

Your Answer:

i changed the calipers on my 07 sebring and still no brakes 1 Answer

changed the calipers and bleed them and still no brakes

2007 Chrysler Sebring

-

Maintenance & Repair
I started my Chrysler Sebring this morning and noticed my check engine light was on what can it possibly be? 4 Answers

I went to start my 2010 Chrysler Sebring this morning and noticed my check engine light had came on what can possibly be the problem?

2010 Chrysler Sebring Limited Sedan FWD

-

Maintenance & Repair
my 99' sebring was low on trans fluid and I put a half quart of the wrong fluid in. my trans went into "limp mode" (stuck in 2nd gear). i did a complete trans flush and this did not fix the problem. the transmission is still stuck in 2nd. can somebody please give me a solution that will not require replacing the trans? 6 Answers

my car was shifting hard into third gear and i checked the trans fluid to notice it was low. i added a half quart of mercron and my car started acting up horribly having a hard time shifting into any ...

1999 Chrysler Sebring LXi Coupe FWD

-

Maintenance & Repair
I disconnected the negative cable then reconnected it on my 2003 Chrysler Sebring Convertible LXI and now the signals don't work? 1 Answer

A coworker and I were troubleshooting my starting issue with the car, so, I knew the 2003 Sebring has a defect with the cpu, basically the engine lights stays on. My car stalled out for no reason afte...

2003 Chrysler Sebring LXi Convertible FWD

-

Maintenance & Repair
My 2000 Sebring heater only runs on high and doesn't put out any heat. Also it will only blow out the middle vents, not defrost or side vents. What should I do and please tell me like I'm a dummy 1 Answer

My 2000 Sebring heater only runs on high and doesn't put out any heat. Also it will only blow out the middle vents, not defrost or side vents. What should I do and please tell me like I'm a dummy

2000 Chrysler Sebring

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.